A simple circuit diagram of the Class B amplifier with the using the S8050 is shown below. Like here the NPN transistor will be S8050 and its equivalent PNP transistor will be S8550.

By complimentary it means that we need a NPN transistor and its equivalent PNP transistor. It is very simple to construct and requires two identical complimentary transistors operate. So let us discuss how that is done.Ī push pull amplifier, commonly known as Class B amplifier is type of multistage amplifier commonly used for audio amplification of loudspeakers. When base current is removed the transistor becomes fully off, this stage is called as the Cut-off Region.Īs mentioned in the features the S8550 transistor is commonly used in push pull configuration with Class B amplifier. This stage is called Saturation Region and the typical voltage allowed across the Collector-Emitter (VCE) or Collector-Base (VCB) could be 20V and 30V respectively. When this transistor is fully biased then it can allow a maximum of 700mA to flow across the collector and emitter. Since it is very high it is normally used for amplification purposes. It has a maximum gain value of 300 this value determines the amplification capacity of the transistor normally S8550. S8550 is a PNP transistor hence the collector and emitter will be left open (Reverse biased) when the base pin is held at ground and will be closed (Forward biased) when a signal is provided to base pin.

Note: Complete Technical Details can be found at the S8550 transistor datasheet given at the end of this article.

Commonly used as Class B Push-pull transistors.

Collector-Emitter voltage (VCEO) is -25 V.

Continuous Collector current (IC) is 500mA.

Low Voltage, High Current PNP Transistor.

Current Drains out through emitter, normally connected to groundĬontrols the biasing of transistor, Used to turn ON or OFF the transistorĬurrent flows in through collector, normally connected to load

Free download pnp transistor